Skip main navigation

Analysis: Conventional interactions

You are now well prepared for drawing and analysing complex Free Body Diagrams.
9.1
In most of our free-body diagrams so far, forces have been applied by strings, so it was easy to know which direction they go in. You can work it out by geometry. It’s not always so easy. We need to be able to represent many different loading situations. Here are some common ones and their conventional representations. The left hand figure shows a heavy beam supported by a roller at one end and a pin joint at the other. The right hand figure shows a free-body diagram. It’s a heavy beam so we’ve included the weight. Can you see that the rollers applies a force perpendicular to the surface it rolls against? And of course it can only push upwards in this case.
55.4
The pin joint can push and pull and it can go sideways too. You can represent its effect by components as shown or by a result and at an angle to some datum. In either case, it requires two quantities. We often neglect friction in the pin joint but if you can’t, you’ll need to add a couple. Here’s another common situation, a built-in end. Common terms are encastre and cantilever. It’s like a pin joint with a lot of friction. The free-body diagram has force components in two directions and an end-fixing moment. The weight of the beam has been neglected in this case.
99.2
If you’re not sure of the sense of force components up or down, left or right, then don’t worry about it too much. If you get it wrong, it generally just comes out negative. There are exceptions. For example, a roller can only push and fix and forces must oppose motion. We’ll see that in week five. Common sense and intuition can help. Check your intuition on this one. If you have a pin joint instruct when the weight can be neglected, then the forces at each end must be equal, opposite, and in the same line. You’ll see the reason in week four.
137.4
If you just show pin joints with two force components at each end, it’s not wrong and you’ll get the right answer, but you are missing out on insights. You’re not exercising your engineers’ eyes. Now you are ready for some tutorial problems and then some design.
You are now well prepared for drawing and analysing complex Free-Body Diagrams.
But for this you will need to know about conventional interactions. How do you represent a beam jutting out from a wall, for instance?
This video will explain.

Talking points

  • Do the conventional interactions make intuitive sense to you?
This article is from the free online

Through Engineers' Eyes: Engineering Mechanics by Experiment, Analysis and Design

Created by
FutureLearn - Learning For Life

Our purpose is to transform access to education.

We offer a diverse selection of courses from leading universities and cultural institutions from around the world. These are delivered one step at a time, and are accessible on mobile, tablet and desktop, so you can fit learning around your life.

We believe learning should be an enjoyable, social experience, so our courses offer the opportunity to discuss what you’re learning with others as you go, helping you make fresh discoveries and form new ideas.
You can unlock new opportunities with unlimited access to hundreds of online short courses for a year by subscribing to our Unlimited package. Build your knowledge with top universities and organisations.

Learn more about how FutureLearn is transforming access to education