Overview of mass spectrometry analysis

Mass spectrometry (MS) is an instrumental technique that is used to determine the mass-to-charge ratio (m/z) of an ion. The measurement of the m/z can provide structural information about a compound of interest (analyte), thus allowing for confirmatory identification. In addition to structural information, MS can also be used for quantitative analysis (ie determining how much of the analyte is present in a sample). The technique is very sensitive, allowing the determination of ultra-trace levels of analytes reaching down to attomolar concentrations (10-18 M). These instruments can also be coupled to liquid or gas chromatography (LC or GC) enabling determination of analytes in very complex samples.

All mass spectrometers consist of an ionisation source, mass analyser and ion detector. The sample is introduced to the mass spectrometer through the ionisation source which ionises the sample. Ionisation of the sample can be achieved in many different ways that can generally be split into ‘hard’ or ‘soft’ ionisation techniques.

Hard ionisation can include electron impact (EI) where a sample in the gas phase is bombarded with electrons leading to ionisation. This process is considered a hard technique as analytes ionised will often fragment extensively, which can lead to a loss of information in regard to the molecular ion (precursor).

Soft ionisation includes electrospray ionisation (ESI), where a sample is introduced through a capillary tip that has an electric potential of 2-5 kV applied. This enables the formation of a Taylor Cone that will emit small charged droplets. With the aid of a desolvation gas, the analytes present in the droplets are transferred to gas phase ions. The technique is considered soft as fragmentation of the molecular ion is reduced, and the molecular ion can then be later fragmented by the mass analyser to provide additional structural information.

Many types of mass analysers exist, such as triple quadrupoles, ion traps and orbitraps among others. In the video shown, Tom and Natsumi were using a triple quadrupole. The triple quadrupole is often used for quantitative confirmatory analysis due to the type of scans that can be performed. These include product ion scans, selected ion monitoring (SIM) and selected reaction monitoring (SRM) among others.

The types of scans are selective as the mass analyser is able to focus on ions of interest, whilst filtering out other ions. For example, in an SRM scan, the first quadrupole is set as a mass filtre so that only one ion of a specific m/z (the precursor ion) is allowed to pass through into the second quadrupole. The second quadrupole is also known as a collision cell, where the precursor ion collides with an inert gas (eg nitrogen) and fragments into smaller fragment ions, known as product ions. The third quadrupole is then also set to filtre so that again only one of the product ions pass through to reach the detector. The process of scanning a specific precursor ion fragmenting into a specific product ion is known as a SRM transition. The transitions can either be used quantitatively (where the most abundant product ion is monitored for) or qualitatively. To identify analytes that may be present within a sample, usually, one quantitative ion and two qualitative ions will be monitored for.

The stages of mass spectrometry: ionization, mass analysis, dissociation, mass analysis and detection Diagram showing electro-spray ionization

Discussion prompt

SRM transitions are selective and useful for identification. Why is it that analysts will normally monitor three transitions (one quantitative and two qualitative) for a single analyte?

Share this article:

This article is from the free online course:

The Science Behind Forensic Science

King's College London

Get a taste of this course

Find out what this course is like by previewing some of the course steps before you join: