Contact FutureLearn for Support
Skip main navigation
We use cookies to give you a better experience, if that’s ok you can close this message and carry on browsing. For more info read our cookies policy.
We use cookies to give you a better experience. Carry on browsing if you're happy with this, or read our cookies policy for more information.

Skip to 0 minutes and 10 secondsWe're going to measure rolling resistance for this toy tractor. We'll pull the tractor with a weight hung over the edge of the table like this, and see what force it takes to keep it moving. We add paper clips to the weight until the tractor keeps moving, after we give it a gentle pull. We want kinetic friction rather than static friction. For fun, we'll see what happens if we increase the weight and arrange for it to hit the ground before the tractor reaches the end of the table. Then, we'll let the tractor roll to a stop. Finally, we'll weigh the tractor and the load so that we can calculate a coefficient of rolling resistance. Have you noticed a problem?

Skip to 0 minutes and 58 secondsWhat about the friction loss when the string goes around the edge of the table? Here's what we'll do. We'll take another piece of the same string and drape it over the table, so that the string doesn't touch the ground at either end. We'll hang the same weight on each end of the string. In this case, we've used paper clip hooks and washers. Next, we'll add washers to one side until the assembly keeps moving after it's given a start. Do you remember the difference between static and kinetic friction? We want kinetic here, steady motion. Once were happy that we've got the right conditions, we'll record our measurements. We'll also need the weight of a clip in terms of washers.

Skip to 1 minute and 44 secondsWe measured this in week three. We'll supply our data during the analysis section. You could move to the analysis now, or you could get on with the next experiment, air resistance.

Experiments on rolling resistance

Finding rolling resistance is simple enough - provided you can measure pull.

The way we’ve measured pull here is satisfyingly elegant.

If you attempt the experiment, take a photo and upload it to our Through Engineers’ Eyes Padlet wall. You can include a link to your photo in the comments for this step (click on your post on the Padlet wall and then copy the web address).

If you don’t have access to a camera, we encourage you to still do the activity and write a description of your experiment on the Padlet wall.

For a guide to using Padlet, please see FutureLearn’s social media help page.

You can download instructions to the experiment in the Downloads section below.

Share this video:

This video is from the free online course:

Through Engineers' Eyes: Engineering Mechanics by Experiment, Analysis and Design

UNSW Sydney